Replacement of the big encoder knob

pandar1	Posted on Mon 21 Oct 2024, 11:35 AM Hi, I would like to replace the large plastic knob on my Essence MK1 with a higher-quality, machined metal one (e.g., the one in the picture). Is it possible to pull it off without causing damage? Is the shaft 6 mm? Thank you. s-l1600.png
KODAMO	Posted on Mon 21 Oct 2024, 06:51 PM Hi, Yes 6mm D shaft. To remove the knob, put two plastic levers under it. Do not apply pressure from only one side as it may damage it.
pandar1	Posted on Mon 21 Oct 2024, 08:53 PM Thank you very much
Rebekka	Posted on Thu 24 Oct 2024, 10:39 AM Hello Pandar, how did it go ? Can I ask where did you get that knob ? Thank you! Rebekka
pandar1	Posted on Thu 24 Oct 2024, 10:59 AM I still have to order it... The one I showed is from ebay https://urly.it/311y0_ it's a little bigger than the stock one... while this one is the same size https://www.ebay.it/itm/264717720482