Forum index > Feature request

Envelope UI

Colin Muir Dorward
I keep trying to add a new break point between two other points by holding one finger on target location while pressing the + button with another. I think this does not work presently. Could it? Is there a different way to do this already?

Another hiccup I'm facing is when the breakpoint is in the top left corner, I have a difficult time selecting it without navigating into "Base" menu, instead. Maybe the selection region for "Base" can be shrunk a bit? Or frame around the envelope window could be expanded a few pixels?

Following these suggestions I have a question: can we already have different curves between different breakpoints? I swear that once I had a combination of linear and log, but I lost it and now I can't figure out how to do it again.

Thanks!
KODAMO
I keep trying to add a new break point between two other points by holding one finger on target location while pressing the + button with another. I think this does not work presently. Could it? Is there a different way to do this already?

Points are always inserted after the currently selected point. Or at the very end if no point is selected. You don't need to hold your fingers on the points while doing another action

Another hiccup I'm facing is when the breakpoint is in the top left corner, I have a difficult time selecting it without navigating into "Base" menu, instead. Maybe the selection region for "Base" can be shrunk a bit? Or frame around the envelope window could be expanded a few pixels?

Best is simply to press more at the right/bottom of the point. There is a huge margin to allow selecting points without having to press exactly on them

Following these suggestions I have a question: can we already have different curves between different breakpoints? I swear that once I had a combination of linear and log, but I lost it and now I can't figure out how to do it again.

Press on an empty area to show the envelope properties. Linear/Exponential applies to the whole envelope
Colin Muir Dorward
Thanks! This is helpful.

Reply