Forum index > Bug report ✓

LFO Delay/Offset bug w/Op LFO AM

Dr.Synth
When using LFO delay delay parameter, together with the LFO Offset (phase) parameter, there is a bug with the interaction with the Operator LFO AM modulation

The current behavior during the LFO delay time gives the Op Volume that is the set value of the OP output on the Base page.

So as you add LFO Offset, the LFO value output stays at the OP output on the Base page value during the delay time, then jumps to the output product of the LFO wave at the offset setting / Op base output. It seems you don't start reading the LFO output value until the dely time ends

You should read-ahead to the LFO wave value at the Offset setting point first, and use that to calculate the proper LFO / AM value output during the delay time

See example Voice -- desired effect is a delayed PWM effect in a square wave. I want the timbre to start as square wave initally and after a short delay start the PWM effect. You can hear that the timbre start as a pulse during the LFO delay, the at the end of the delay time immediately jumps to the square wave timbre resulting from the LFO Value at the Offset (phase) setting of 32.

Manny
KODAMO
You're right that it makes more sense to handle the LFO this way, this will be included in v4.5 firmware.
Thank you for reporting.
Dr.Synth
Cool, thanks again !

Reply